The wall transparent waterproof plastic Features: non-toxic, environmental protection, waterproof can be used for drinking water, pool. Permeability, and strong bonding, the slurry of the active ingredients can penetrate into the cement base surface pores, the microcrack 3-5mm, blend with the substrate, forming a crystalline dense waterproof layer. Even in the case of damage to the epidermis is not easy to produce leakage. Anti-aging properties, construction is simple, can moist basic plane. Good flexibility, can withstand the slight vibration of the building and micro-cracks. Directly paint for interior and exterior waterproofing, trapping, waterproof membrane to form a transparent and does not affect the appearance. Scope: brushing directly to the interior and exterior wall trap water. Kitchen, bathroom, warehouses, basements, reservoirs, roads and other waterproof. The Dosage: brushing directly 0.2-0.4kg/m2. With cement brushing 0.6-1kg/m2. Construction program base surface treatment: clean the base surface should be smooth and firm, without hollowing. Pores, trachoma is required with cement mortar to fill the flat, sharp edges should be removed. Such as high temperatures or drier base surface, before the construction of the application of water to fully wet to ignorance and water shall prevail. Construction technology for interior and exterior trap, waterproof, To maintain the original appearance, the emulsion can be painted to the basal plane. RS-401 into the mixing bucket, stirring slowly added to the cement powder edge with an electric mixer, stir until evenly without powder, no precipitation can be used. Asked to join the cement 425 # portland cement, cement is added in an amount of: liquid material: cement = 1:0.8. Direct brushing with a brush or roller in good base surface, can not be missed brush, brushing if holes should be repeated brushing the gas discharges. After brushing first pass should be treating its table (just sticky) after brushing the second time, the second brushing direction should be staggered to the front again, brushing a thickness of not more than 0.6 mm, so as not to affect the construction effect . Note: can not be below 0 ℃ or rain construction, the stirred slurry should be used within 2 hours. The air is particularly humid, unventilated area ventilation equipment should be used to speed up the waterproof layer to dry. Within 24 hours after construction shall not test the water and completely dry before do other overburden layers.